H- CMD7071
DVD/MP3/CD-RECEIVER
DVD/MP3/CD-
Instruction manual
Important safeguards
Using the device at temperature below -10º may cause the breakage of the device. BEFORE USING PLEASE
HEAT UP THE PASSENGER COMPARTMENT TO THE RECOMMENDED TEMPERATURE!
Read carefully through this manual to familiarize yourself with this high-quality sound system.
Disconnect the vehicle's negative battery terminal while mounting and connecting the unit.
When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher
amperage rating may cause serious damage to the unit.
DO NOT attempt to disassemble the unit. Laser beams from the optical pickup are dangerous to the eyes.
Make sure that pins or other foreign objects do not get inside the unit; they may cause malfunctions, or create
safety hazards such as electrical shock or laser beam exposure.
If you have parked the car for a long time in hot or cold weather, wait until the temperature in the car becomes
normal before operating the unit.
DO NOT open covers and do not repair yourself. Consult the dealer or an experienced technician for help.
Make sure you disconnect the power supply and aerial if you will not be using the system for a long period or
during a thunderstorm.
Make sure you disconnect the power supply if the system appears to be working incorrectly, is making an
unusual sound, has a strange smell, has smoke emitting from it or liquids have got inside it. Have a qualified
technician check the system.
The unit is designed for negative terminal of the battery, which is connected to the vehicle metal. Please confirm
it before installation.
Do not allow the speaker wires to be shorted together when the unit is switched on. Otherwise it may overload or
burn out the power amplifier.
Do not install the detachable panel before connecting the wire.
3
Installation/Connections
First complete the electrical connections, and then check them for correctness.
Installation opening
This unit can be installed in any dashboard having an opening as shown below. The dashboard should be 4.75 ± 5.56
mm thick in order to be able to support the unit.
1. Insert mounting collar into the dashboard, and bend the mounting tabs out with a screwdriver.
Make sure that lock lever
is flush with the mounting collar (not projecting outward).
2. Secure the rear of the unit.
After fixing mounting bolt and power connector, fix the rear of the unit to the car body by rubber cushion.
3. Insert trim plate.
When you prepare to insert trim plate, please check it s direction. Once it was up side down, it cannot be fixed.
IMPORTANT: Remove
these two screws before
installation. Otherwise,
the DVD Player will not
work
4
Electrical connections
5
Do not interchange the connection of the wiring!!!
For some car models you may need to modify wiring of the supplied power cord as illustrated (modified wiring), or
else the memory of the unit may be lost after you power off. Contact your authorized car dealer before installing this
unit.
Using the ISO Connector
1. If your car is equipped with the ISO connector, then connect the ISO
connectors as illustrated.
2. For connections without the ISO connectors, check the wiring in the vehicle
carefully before connecting, incorrect connection may cause serious damage to
this unit.
Cut the connector, connect the colored leads of the power cord to the car battery
as shown in the colour code table below for speaker and power cable
connections.
Location
FUNCTION
Connector A
Connector B
1
2
3
4
5
6
7
8
Rear Right(+)---Purple
Rear Right(-)---Purple/Black Stripe
Front Right(+)---Gray
Front Right(-)---Gray/Black Stripe
Front Left(+)---White
Front Left((-)---White/Black Stripe
Rear Left(+)---Green
Rear Left(-)---Green/Black Stripe
Battery 12V (+)/yellow
Auto Antenna/blue
ACC+/red
Ground/black
6
Panel controls
Front panel
1. POWER BUTTON.
Press POWER/MUTE in 1 second to MUTE ON, press it again 1 second to MUTE OFF.
Press more than 2 seconds POWER/MUTE to power off.
2. LCD (LIQUID CRYSTAL DISPLAY).
3. OPEN BUTTON.
Press it to flip down the front panel and you can insert the disc into the compartment or press the EJ button to
eject the disc from the disc compartment.
4. LOUDNESS
5. FM STEREO/MONO
6. LOCAL/DX BUTTON
7. BAND BUTTON.
Press it repeatedly to select your desired radio band during RADIO mode.
8. AMS BUTTON (AUTO-PRESET/PRESET SCAN).
7
9. PRESET STATION [1-6] AND RPT, RDM BUTTONS.
1. Disc playback: Play/ Pause.
2. Disc playback: Intro play (10 seconds).
3. Disc playback: Track repeat play.
4. Disc playback: Track random play.
5. VIDEO MODE BUTTON (PAL/NTSC).
6. AUDIO CHANEL SWITCH BUTTON (L/R/ST).
10. SRC BUTTON. Press it to select RADIO, CD or AUX mode.
11. DISPLAY SWITCH
12. VOLUME-UP/DOWN, MENU-UP/DOWN.
Back of the front panel
Press the
button to open the panel and press
to eject the disc.
Disc eject
Disc slot: insert a disc for playback here
Reset hole
Panel status indicator
8
Note: Pressing the RESET hole will erase the clock setting and stored stations.
Panel status indicator lights up when you slide the panel down; flashes when you remove the panel.
ISO connector
PLEASE USE ONLY ORIGINAL CONNECTOR WHICH GOES WITH SET.
Note:
In spite of having any kinds of speaker system, must use 4 ohms impedance of speaker to reduce the distortion
during high volume level.
9
Remote control
1. ZOOM button
2. TITLE button
3. Power on/off
4. Setup button
5. Directional buttons for menu selection
6. ENTER button
7. PROGRAM button
8. Digit area
9. SELECT button (to select basic sound setting options)
10. VOLUME button
11. MUTE button
12. RADIO TUNE/SEARCH button
13. Select subtitle language
14. SRC button
15. REPEAT button
16. A
B button
17. STOP button
18. PLAY/PAUSE button
19. GOTO button
20. MENU PBC button
21. On Screen Display button
22. AUDIO button
23. DISPLAY button
24. ANGLE button
25. VIDEO mode/RADIO band button
10
Battery information of remote controller
1. Press the catch and at the same time pull out the battery tray.
2. Insert the 1 x lithium battery, type CR 2025 3V battery with the stamped (+) mark facing
upward. Insert the battery tray into the remote control.
WARNING: Store the battery where children cannot reach. If a child accidentally swallows the battery, consult a
doctor immediately.
Do not recharge, short, disassemble or heat the battery or dispose it in a fire.
Do not expose or bring into contact the battery with other metallic materials. Doing this may cause the battery to give
off heat, crack or start a fire.
When throwing away or saving the battery, wrap it in tape and insulate; otherwise, the battery may give off heat,
crack or start a fire.
11
Glossary
PBC (PlayBack Control)
PlayBack Control is a menu recorded on the disc with SVCD or VCD2.0 format. For the discs contained PBC, it can
playback interactive software with the menu displayed on TV. And if the disc contains still images, it can playback
high definition of still image.
Title
The title is the important part of DVD disc. The memory volume of the disc is rather big, that makes possible to
record several films on one disc. For example, if a disc contains three films, they may be divided into Title 1, Title 2
and Title 3. You can easy use the functions of looking-for.
Chapter
A title can be divided into several blocks, so that every block can be operated as a unit, the unit is called chapter. The
chapter contains a unit at least.
Track
It is the biggest component of VCD. Generally, every song of karaoke disc is a track.
12
Features
Fully compatible
Fully compatible with the most popular discs formats such as DVD, CD, CD-R (containing MP3, JPEG), CD-RW
represented in the market.
Upgrade intelligently
Support the function of upgrading the software for playing discs of new formats to keep up with the market
competition.
Strong output function
The player has an analogue audio output of 2 channels, digital audio output and video output of complex video.
Supports picture CD, Photo CD
Fully compatible with Picture CD and Photo CD without setting additional software. It automatically activates the
media player menu to process.
Screen saver
Supports the screen saver function. If there is no operation or no disc during 5 minutes, the player will automatically
turn into the state of screen saver. It can prolong the serviceability of the player.
13
Compatible discs
DVD Video
DVD disc include video and audio data. The data can contained by the 12 cm diameter of DVD disc is 7 times of one
can contained by the common CD-R disc. Its maximum continuous playback time can be up to 2 hours (one of
double-sided disc can be up to 4 hours). DVD disc sort as 4 kinds of ones: single-layer and double-layers and
single-sided, single layer and double-sided, double-layers and double-sided disc.
SVCD
Super VCD disc adopt MPEG-II compression way. It can provide better quality of video than VCD disc. And it can
record 2 stereo audio track. Super VCD disc can also supports wide screen.
VCD2.0
Compare with VCD1.1 disc, VCD2.0 disc has a playback list. Generally, Karaoke disc with VCD2.0 format has a
PBC menu.
VCD1.1
Picture CD disc its size is same as audio CD disc include audio and video data. The maximum playback time of the
standard 12 cm of disc with VCD1.1 is 74 minutes.
DVCD
Compatible with DVCD disc. DVCD disc is high density of VCD disc. Compared with VCD disc, a DVCD disc can
contain more data.
CD-DA
Compatible with CD-DA disc. CD-DA disc include audio data. The maximum playback time of the standard 12 cm
of CD-DA disc is 74 minutes.
MP3/JPEG
Compatible with CD-R/CD-RW/CD-ROM discs contained files with MP3/JPG format. Also supports JPG pictures
playback with MP3 tracks as background music, provides fine video and audio effect.
14
Picture-CD
Compatible with Picture-CD disc. Do not need setting the additional software. Picture-CD is a disc format that stores
photo with electronic file format developed by Kodak company.
Photo-CD
Compatible with Photo-CD disc. Do not need setting the additional soft ware. Photo-CD is a disc format that stores
photo with electronic file format developed by Konica company.
CD-R/CD-RW
Compatible with CD-R/CD-RW disc with ISO9660 specification include the format of MP3, JPG, JPEG, Ac3,
PCM, MPG, MPE.
DVD+/-R
Compatible with DVD+/-R disc with UDF specification include the format of MP3, JPG, JPEG, Ac3, PCM, MPG,
MPE.
15
General operation
Power button
Press
Press
button on the front panel or any other button on the panel except
to switch the set to POWER OFF. When you switch off the system or car ignition, the settings, tuner
to turn on the unit.
presets and the volume level will be retained in the unit s memory.
SRC button
Press SRC button once or more to select your desired function: DISC, RADIO, Aux (Aux-in), Tuner (Radio).
If you select Radio mode, press BAND once or more to select FM1, FM2, FM3, FM(OIRT), MW1, MW2.
Vol knob button
Push the VOL control to select VOL/BAS/TRE/BAL/FAD, rotate the control to adjust.
- VOLUME control
Display shows the volume level VOL and number from 0 to 63.
- BASS control (will be available when DSP is OFF)
Display shows the BASS level
- TREBLE control (will be available when DSP is OFF)
Display shows the TREBLE level
- BALANCE control
Display shows the BALANCE level
16
- FADER control
Display shows the FADER level
Push the knob for more then 2 seconds to select EQ/BEEP/24 HOURS/VOL LAST.
Rotate the knob to select EQ (NORMAL/POP/ROCK/CLASSIC), Beep (ON/OFF), A-Vol, Vol (LAST/ADJ).
Loud key function
|